Kenmore 59650394001 Guía Para El Uso Y Cuidado página 7

CAUTION I
To avoid personal injury or property damage, handle
tempered glass shelves carefully. Shelves may break
suddenly if nicked, scratched, or exposed to sudden
temperature change.
Remove shelf and crisper drawers by completing the
following steps:
1. Open crisper.
2. Remove shelf by gently pushing up from underneath.
Tilt one end up then pull out.
3. Remove crisper by lifting front while supporting
underneath then pulling out.
4. Replace crispers and shelf by reversing steps 1-3.
Bottle Rack (some models)
Bottle rack provides convenient storage for a large bottle,
eggs, etc.
• Hang rack by hooking over side of shelf.
Bottle
rack
Covered Storage Bucket (some models)
Storage bucket has a lid and removable egg tray. When tray
is removed, bucket will accept items such as a standard
egg carton, ice, etc.
Lid
Egg tray
Stora(
Dairy Center
Dairy center provides convenient storage for items such as
butter, cheese, etc.
Dairy center is adjustable to accommodate storage needs.
Dairy center may also be removed for cleaning. To remove
dairy center perform the following steps:
• Remove dairy center cover by opening cover. Push cover
inward at pivot points and pull cover out. Lift dairy center
up and pull out to remove.
• Replace dairy center by reversing procedure.
Dairy
center
Dairy
center,
cover \
Milk Savor
TM
The Milk Savor
TM
keeps beverages up to 5°F (3°C) colder
than refrigerator section. Air inlet allows air from freezer
section to pass to Milk Savor
TM.
Air inlet is located on
interior wall of refrigerator door.
Milk Savor
TM
control is located on left front wall of
refrigerator section.TM Control adjusts amount of air circulating
in Milk Savor .Turn control to COLD for normal refrigerator
temperature and to COLDER for colder temperature.
Tum control
colder
II
Milk Savor
TM
Savor
TM
temperature
Milk Savor
TM
position is adjustable to accommodate storage
needs. Milk Savor
TM
may also be removed for cleaning. To
remove Milk Savor
TM
perform the following steps:
1. Grasp Milk Savor
TM
by sides, lift up and pull out to
remove. Remove bottom of Milk Savor
TM
by pushing
up and pulling out.
To replace Milk
Savor
TM,
slide Milk Savor
TM
bottom
between desired shelf rails in door liner and push down
into place. Slide Milk Savor
TM
top between desired
shelf rails in door liner and push Milk Savor
TM
top
down into place over Milk Savor
TM
bottom.
• Notch in door dike must line up with one of Milk
Savor
TM
cold air intakes holes.