Baby Jogger summit X3 Instrucciones De Ensamblaje página 13

CANOPY
14 Attach the canopy to the frame:
Slide the canopy peg into the top
hole of the Accessory Mounting
Bracket until it clicks into place.
NOTE: Make sure the elastic
fabric is out of the of the
Accessory Mounting Bracket.
15 At the top and on the side of the
Canopy, snap the webbing together
around the top of the frame on both
sides.
16 Secure the canopy by aligning the
hook and loop strips on the side of
stroller and canopy.
17 Remove the canopy: Press the
top gray button on the accessory
mounting Bracket to release the
canopy peg and unfasten snaps and
hook and loop patches at the top of
the canopy.
18 ON CERTAIN MODELS: To use the
canopy window, fold shade up and
secure with magnets.
19 ON CERTAIN MODELS: To use the
side vents, roll the vent cover and
secure with elastic and button, or lift
the vent cover and attach magnets at
ends of vent covers.
ADJUSTING SAFETY HARNESS
20 From the back of the seat, undo the
fastening strip and open the pocket
to locate the plastic square stopper.
Turn stopper and pass through the
openings in the PE board and seat
fabric.
21 Reinsert stopper at seat opening
closest to child's shoulders. Pass back
through seat fabric and PE board.
Tug on strap to ensure stopper is
locked. Repeat on both sides.
WARNING: Avoid serious injury from
falling or sliding out. Always use the
crotch strap in combination with the
shoulder straps and waist belt.
WARNING: Always ensure that the
5 point harness is firmly adjusted to
securely fit your child.
22 Slide the harness pads up to access
plastic guide on strap.
23 Hold the plastic guide and pull strap
to tighten or loosen.
USING SAFETY HARNESS
24 Insert side strap buckle into harness
buckle on both sides.
25 Insert connected harness and side
strap buckles into the sides of the
crotch buckle.
26 Press button on crotch buckle to
release.
RECLINE THE SEAT
27 Pinch the clamp behind the seat, and
slide it down to desired recline.
28 Pull seat down on both sides to
match the clamp position. Reverse
steps to return to the upright position.
WARNING: When making
adjustments to the stroller seat, make
sure child's head, arms, and legs are
clear of moving seat parts and stroller
frame.
Do not recline the seat while jogging.
29 For extra ventilation, roll up the seat
back flap and secure with elastic and
button.
REMOVING THE SEAT PAD
30 Remove the canopy. Starting with
the top snap closest to the handle
and working your way down the
entire frame, unsnap seat from frame.
31 Unfasten the seat straps from around
the bottom/back of the frame,
located behind the front wheel.
32 Locate the fold strap rings connected
to the stroller frame underneath
the stroller seat. Unscrew the fold
strap rings and unhook from the fold
mechanism.
33 Slide fabric out of the footwell area.
Reverse the steps to reattach the seat pad
to the frame.
13
EN