Fm/Am Tuning; Automatic Tuning - Yamaha R-S300 Manual De Instrucciones

FM/AM TUNING

There are 2 tuning methods; automatic and manual. Select either method according to your preference and the strength of
station signals.
Note
Be sure to set the tuner frequency step according to the frequency spacing in your area before you tune into a radio station. See page 31 for the
tuner frequency step setting.

Automatic tuning

Automatic tuning is effective when station signals are
strong and there is no interference.
1
Rotate the INPUT selector on the front panel
(or press FM or AM on the remote control) to
select TUNER as the input source.
Note
If you press FM or AM on the remote control to select TUNER as
the input source, the corresponding band is also selected,
therefore you may skip step 2.
2
Press FM or AM on the front panel (or FM or
AM on the remote control) to select the
reception band (FM or AM).
FM or AM is displayed on the front panel display.
18
En
FM/AM TUNING
INPUT selector
TUNING jj / ii
FM, AM
FM, AM
3
Press and hold TUNING jj / ii on the front
panel for more than 1 second to begin
automatic tuning.
Press ii to tune in to a higher frequency.
Press jj to tune in to a lower frequency.
Notes
• When you tune in to a station, the frequency of the station is
displayed on the front panel display.
• If the tuning search does not stop at the desired station because
the station signals are weak, try using the manual tuning
method.
■ Auto Mute feature
When listening to an FM radio station, the output will
automatically be muted when the radio signal is weak if
the station was tuned in to by:
• using the automatic tuning feature
• recalling a preset that was registered using the
automatic preset registration feature
If you want to listen to a station that has a weak signal,
tune in to the station manually.