Yamaha R-S300 Manual De Instrucciones página 30

PLAYING BACK TUNES FROM YOUR iPhone/iPod/Bluetooth™ COMPONENT
■ Playing back Bluetooth
MEMORY
DOCK
B / C
ENTER
OPTION
When pairing is complete, carry out the following
procedure to achieve a wireless connection between this
unit and the Bluetooth component.
When the wireless connection is complete, you can enjoy
playback from Bluetooth components.
Note
Depending on the Bluetooth component, a wireless connection is
established automatically or when the Bluetooth component is
operated. In these cases, it is not necessary to carry out the
following procedure.
1
Rotate the INPUT selector on the front panel
(or press DOCK on the remote control) to
select DOCK as the input source.
2
Press OPTION on the remote control.
The Option menu for DOCK displayed (see page 29).
28
En
TM
components
INPUT selector
3
Press B / C on the remote control to select
"Connect", and then press ENTER.
When wireless connection is complete, "Connected"
is displayed on the front panel display.
To exit the Option menu, press OPTION on the
remote control.
Note
"Not found" is displayed if there is a connection error. Check that
the following conditions have been satisfied, and try to establish a
wireless connection again.
• Both this unit and the Bluetooth component are paired.
• The Bluetooth component is switched on.
• The Bluetooth component is within 32 feet/10 meters of the
Bluetooth wireless audio receiver.
4
Operate the Bluetooth component for
playback.
While the Bluetooth component is playing,
"BLUETOOTH" is displayed on the front panel
display.
Note
To disconnect a wireless connection, repeat these steps and select
"Disconnect" in step 3.
y
When the input source is set to DOCK, you can also establish a
wireless connection by pressing MEMORY on the front panel (or
ENTER on the remote control).