Publicidad
Idiomas disponibles
Idiomas disponibles
10. Locate gun assembly (Q) and place inside cabinet. Using
the compression nut you removed from the manifold
assembly, slide nut onto the gun's polyurethane tubing in
the orientation as shown below. Firmly push the tubing
onto the compression fitting until it is seated fully against
the shoulder. While holding the tubing in place, tighten the
compression nut until snug. Do not overtighten.
11. Slide the suction hose from the gun over the suction
pickup tube (the longer tube as shown). Hose should be
inserted approximately one inch onto tube. Secure hose
by tightening hose clamp.
10
Publicidad
