Publicidad
Idiomas disponibles
Idiomas disponibles
12. Install vibration module (T) onto the bottom right of hop-
per using the fasteners provided with it. Orient the module
with the push lock fitting on the right side as shown below.
Tighten fasteners securely. Insert the 6mm polyurethane
tubing (R) into the fitting and push in until it is seated fully.
Insert the other end of the tubing into the push lock fitting
on the manifold assembly (P).
13. Carefully pull gun assembly outside of the cabinet and
let hang. Locate grate (J) and orient it face up with the
(3) supports on the bottom. Turn grate at an angle with
notched corner at front right and insert it into the cabinet
as shown below. Once the grate is inside the cabinet, lay
it flat on the bottom and return the gun assembly to the
inside of the cabinet.
11
Publicidad
