Publicidad
Idiomas disponibles
Idiomas disponibles
14. Locate the foot valve assembly (U) and remove compres-
sion nut from the fitting. Locate the 12mm polyurethane
tubing (S) and slide nut onto tubing in the orientation as
shown. Firmly push the tubing onto the compression fitting
until it is seated fully against the shoulder. While holding
the tubing in place, tighten the compression nut until snug.
Do not overtighten.
15. Remove compression nut from the elbow fitting on the
manifold assembly (P). Slide nut onto tubing in the ori-
entation as shown. Firmly push the tubing onto the com-
pression fitting until it is seated fully against the shoulder.
While holding the tubing in place, tighten the compression
nut until snug. Do not overtighten.
16. From outside rear of cabinet locate rear vent panel (X),
threaded knob (Y) and flat washer (EE). Insert threaded
portion of knob through center hole of vent panel. Place
washer onto threads and install vent panel using threaded
knob. The flat washer should be between the vent panel
and the back of the cabinet. Tighten the knob securely.
Align the holes of the panel with those in the cabinet.
17. From the outside rear of cabinet locate rear exhaust port
(V) and install in the orientation as shown. Using (3) of bolt
(E), attach port to cabinet and tighten securely.
12
Publicidad
