Publicidad
Idiomas disponibles
Idiomas disponibles
7.
With a helper, carefully stand the cabinet upright. Stand in
front of the cabinet and insert your hands into the gloves.
Determine if the height of the cabinet is comfortable at
this setting. If you feel that the cabinet is too high or too
low, carefully lay the cabinet on the floor on its back (with
a helper). Remove the fasteners securing the long legs
to the short legs and slide the (4) long legs up one hole
location if the cabinet seems too high or down one hole
location if the cabinet seems too low. Reinstall all fasten-
ers and tighten. Using a helper, carefully stand the cabinet
upright and recheck to see if the height is correct.
8.
Using bolt (A) and nut (B), install the (2) long cross sup-
ports (N) and (2) short cross supports (O) on the inside
surfaces of the legs. Place the nuts on the inside of the
legs as shown but do not tighten. After all (4) cross sup-
ports are installed, tighten all fasteners.
9.
Unlatch and open cabinet door. Locate the manifold
assembly (P) and remove the compression nut, straight fit-
ting and the flat washer. Set the compression nut aside
for use in the next step. Apply 2-3 wraps of Teflon tape
to the threads on the straight fitting. Insert threads of
straight fitting from the inside of the cabinet through the
hole located on the lower right side. Install flat washer on
the outside of the cabinet. Assemble the manifold assem-
bly to the fitting and tighten. Orient manifold assembly
with push lock fitting and compression fitting elbow point-
ing down.
9
Publicidad
