Publicidad
Idiomas disponibles
Idiomas disponibles
PARTS LIST
Item
Description
R
6mm O.D. polyurethane tubing
S
12mm O.D. polyurethane tubing
T
Vibration Module w/fasteners
U
Foot Valve Assembly
V
Exhaust Port
W*
Exhaust Port Cover
X
Vent
Y
Threaded Knob for Vent
Z
Suction hose, black
AA
2½" Hose clamps
BB
Power Supply for light
CC
Cyclone
DD
Cyclone gasket (not shown)
EE
Flat washer
FF
Hose Adaptor
* Exhaust Port Cover not needed if cyclone is installed.
ADDITIONAL ITEMS NOT SHOWN:
•
QTY.
(2) Rolls of cabinet seal (extra seal for future use not
needed for installation unless pre-installed seal damaged)
20"
•
(1) Extra 6mm nozzle and (2) 7mm nozzles
48"
•
(5) Window film sheets
•
1
(1) Cyclone mounting template
•
(1) Gloves
1
1
ITEMS NOT INCLUDED:
•
1
Teflon tape
•
5 Gallon bucket w/lid
1
•
Shop Vacuum
1
•
Abrasive Media
40"
Unit Assembly Instructions: Use the parts list and Fig 2 for ref-
2
erence when assembling. Also, it is recommended that you use
1
two people with lifing and assembling this product.
1
1.
Open box and remove all components from inside of box
1
and from the main cabinet assembly. Open all smaller boxes
1
and place all components on the floor in an orderly fashion.
2.
Lay the main cabinet assembly (H) on its back using a blan-
1
ket (or some other material) to prevent scratching during
assembly. Carefully open both latches and slowly open the
door.
3.
Locate hopper (I) and orient it with the holes on the right
side of the cabinet as shown on next page.
7
Publicidad
