LG DLE3600 Serie Manual Del Propietário página 267

30
TROUBLESHOOTING
ERROR CODES
Problem
The display shows:
The display shows:
Washer fills with water slowly or
not at all, or the display shows:
Washer will not turn on
Water in the washer drains slowly
or not at all, or the display shows:
Washer chimes repeatedly before
final rinse
Possible Cause
Drawer is not closed properly
Lid is not closed properly
Water supply faucets are not fully
open.
Water line hoses are kinked,
pinched, or crushed.
Water inlet filters are clogged.
Water supply pressure to faucet or
house is too low.
Water supply connected with leak-
limiting hoses.
Power cord is not properly
plugged in.
House fuse is blown, circuit break-
er has tripped, or power outage
has occurred.
Drain hose is kinked, pinched, or
clogged
Drain discharge is more than 53
" (134.6 cm) above bottom of
washer.
This is not an error. This is an alert
to allow the addition of liquid fab-
ric softener before the final rinse..
Solutions
Close the drawer and press START/PAUSE
button to start the cycle.
If the drawer is closed and the drawer lock
error message is displayed, call for service
Open the drawer and make sure the latch
area is free of clothing or other obstructions.
Close the lid, shut the drawer, and press
START/PAUSE to start the cycle.
If the lid is closed and the lid error message
is displayed, call for service
Make sure that the water faucets are fully
open.
Make sure that the hoses are not kinked or
pinched. Be careful when moving the washer
during cleaning and maintenance.
Clean the inlet filters. See Maintenance in
the Care and Cleaning section.
Check another faucet in the house to make
sure that household water pressure is ad-
equate and flow is not restricted. Disconnect
the inlet hose from the washer and run a few
gallons of water through the hose to flush
the water supply lines. If flow is too low,
contact a plumber to have the water lines
repaired.
Hoses designed to limit leaks can trip falsely
and prevent the washer from filling. The use
of leak limiting hoses is not recommended.
Make sure that the plug is plugged seruely
into a grounderd, 3-prong. 120-VAC, 60-Hz.
outlet.
Reset circuit breaker or replace fuse. Do not
increase fuse capacity. If the problem is a
circuit overload, have it corrected by a quali-
fied electrician.
Make sure the drain hose is free of clogs,
kinks, etc., and is not pinched behind or
under the washer.
Adjust or repair drain. Maximum drain height
is 53 " (134.6 cm).
See Using Fabric Softener, page 16, for
instructions on adding liquid fabric softener
to the load.
To disable or enable the fabric softener alert,
press and hold Warm Water and Extra Rinse
at the same time for three seconds.