36 MAINTENANCE
• Do not exceed the maximum fill line when
adding bleach or powdered cleaners.
Powdered cleaners may remain in the drum
after cleaning.
3
Close the door and press the Power button.
4
Select the Tub Clean cycle then press the
Start/Pause button to begin the cycle.
5
After the cycle ends, open the door and allow
the drum interior to dry completely.
WARNING
• Make sure children and pets do not climb into
the drum. Engage the Control Lock feature if
needed to prevent children from accidentally
starting a wash cycle.
NOTE
• If you use a descaler or drum cleaner during the
Tub Clean cycle, use the Rinse+Spin option to
rinse the washer drum before running your next
wash cycle.
Automatic Alert for Tub Clean
When the power is on and the
on the display, it means the washer drum needs
cleaning. Use the Tub Clean cycle to clean the
washer drum. The frequency of the automatic
alert's appearance depends on how often the
washer is used. However, the message will
generally appear every one to two months.
Removing Mineral Buildup
In areas with hard water, mineral scale can form
on internal components of the washer. Periodically
clean the mineral buildup on the internal
components to extend the lifespan of the washer.
Use of a water softener is recommended in areas
with hard water.
• Use a descaler to remove visible mineral buildup
on the washer drum.
• After descaling, always run the Tub Clean cycle
before washing clothing.
• Mineral scale and other spots may be removed
from the stainless steel drum using a soft cloth
soaked in stainless steel cleaner.
• Do not use steel wool or abrasive cleaners.
message blinks
tcL
Leaving the Door Open
After you finish using the washer, leave the door
open overnight to allow air to circulate and dry the
drum. This helps prevent odors.
Cleaning the Dispenser Drawer
Leaving detergent in the detergent dispenser
drawer for an extended period of time or using the
washer for a long period of time may cause the
build-up of residue in the detergent dispenser
drawer. Remove and clean the detergent
dispenser drawer once or twice a month.
WARNING
• Do not spray water inside the washer. Doing so
may cause fire or electric shock.
1
Turn off the washer, and unplug the power
cord.
2
Pull the drawer straight out until it stops.
3
Press down hard on the disengage button
and pull the drawer completely out.
4
Remove the inserts from the drawer.
5
Clean the inserts and drawer with warm
water.
• Use a soft cloth or brush to clean and to
remove any residue.
• Do not use soap when cleaning the drawer
and inserts.
6
Wipe off any moisture with a dry towel or
cloth after cleaning.
7
To clean the drawer opening, use a small,
non-metal brush to clean the recess. Remove
all residue from the upper and lower parts of
the recess.
a