Publicidad
Idiomas disponibles
Idiomas disponibles
Incorrect installation (see picture 05 on
page 6)
• It is important to keep the duct
unblocked. Incorrect installation will
affect the effectiveness of the appliance.
• Prevent the exhaust duct from kinking.
• Make sure that air can flow through the
duct.
Window kit installation
Your window kit has been designed to fit
most standard "vertical" and "horizontal"
window applications. However, it may be
necessary for you to improvise/modify
some aspects of the installation procedures
for certain types of windows.
(See picture 06 on page 6).
(See picture 11 on page 7).
• Minimum distance: 27-1/ 2" (70 cm).
• Maximum distance: 48 (122 cm).
Depending on the portable AC purchases,
window kit could be fixed to the window
by screws or by a clip (see pictures 07 and
08 on page 6).
If your kit uses screws (See picture 09 on
page 7):
• Measure the size of the window;
• Adjust the length of the plate according
to the size of the window.
• Fix the plate with a screw
If your kit uses clips (See picture 10 on page
7):
• Measure the size of the window;
• Adjust the length of the plate according
to the size of the window;
• Block the plate.
Casement windows' kit
If you have a casement window, please
note that the window kit included with
this appliance is not compatible.
In case of a casement window, we suggest
to purchase the corresponding kit through
a MediaMarkt shop.
The air exhaust hose mounting method
The air exhaust hose is 20cm-160cm in
length. It is suggested that the hose should
be as short as possible to achieve the
maximum energy efficiency ratio when
the air conditioner works. If there is a need
to extend the hose, please adopt the best
mounting method as the figure shows. And
please, also pay attention to the following
points:
• Try to avoid the bendings of the hose.
• Try to avoid the bendings of the hose
near the exhaust air outlet (and the
bending point should be at least 50cm
away from the exhaust air outlet) (see
picture 12 on page 7).
• Keep the smoothness of the whole air
exhaust hose, especially in the bending
points. Avoid any abrupt steep-angled
bendings.
USING THE APPLIANCE
This device is easy to use and does not
require much knowledge. However, we
advise you to familiarize yourself with the
instructions below.
(
Control panel
see picture 13 on page 7)
13. On/Off
14.
Mode selector
15. Mode indicator (light)
16. Increase button
17. Display
18. Decrease button
19. Speed indicator (light)
20.
Speed (low/middle/high)
21. Timer
22.
Wi-Fi
(
Remote control
see picture 14 on page 8)
The device incorporates a remote control,
for a more comfortable and efficient use.
In order for the remote control to work, it
must always be aimed at the fan.
Before you start using it, please take a few
minutes to familiarize yourself with the
functions:
EN
33
Publicidad
