Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
23.
Display
24.
On/Off
25.
Mode selector
26.
Increase button
27.
ºC to ºF (and reverse)
28.
Swing
29.
Decrease button
30.
Speed (low/middle/high)
31. Timer
Please note the following information:
• Do not place the controller near
something with high temperature like
an electric heating bed cushion or a
heating radiator.
• Do not place the controller at places
directly exposed to the sunlight or
strong lights.
• Avoid
accidental
controller, which might cause damage
to it.
• Do not place blocking objects between
the air conditioner and the controller;
• Do not splash water or other liquids to
the controller.
• Do not put heavy objects on the
controller.
• If
the
remote
functioning, replace the batteries and
try once again.
Cool mode
• After power on, initial seeting is cooling
mode; or after cooling mode is selected,
the cooling indicator lamp will light up.
• Press Up/Down key to adjust setting
temperature from 16ºC to 30ºC.
• Press Speed key to choose between
High/Mid/Low.
Fan mode
• After Fan mode is selected by the
remote controller, the wind indicator
lamp lights up.
• Press Speed key to choose between
High/Mid/Low speed.
• Temperature can't be setted.
Dry mode
• When dry mode is selected, the dry
34
dropping
of
the
controller
is
not
indicator lamp lights up.
• Take off the water plug that back of the
unit as shown in the picture, insert the
water pipe (probably not included in
the package), and put the other end into
a water tank or to a drainage channel.
• Under dry mode, the compressor starts
when the room temperature is higher
than 17ºC ( 63ºF ). In the same manner,
the compressor follow below rules:
• When the room temperature ≤15ºC
(59ºF) , the comp ressor shuts down.
• When the room temperature ≥17ºC,
the
compressor
will be three-minute after due to
protection function).
• In dry mode, the fan is defautled to run
at low speed, and wind speed can't be
adjusted
• Temperature can't be set.
Notes: under dry function, exhaust pipe
should be removed or performance will be
effected and "FL" water full alarm will
blink.
Heat mode
• After Heat mode is selected by the
remote controller, the wind indicator
lamp lights up.
• Press Up/Down key to adjust setting
temperature from 16ºC to 30ºC.
• Press Speed key to choose between
High/Mid/Low.
CLEANING AND MAINTENANCE
WATER DRAINAGE
The air conditioner evaporates condensed
water and discharges the moisture through
the hot air outlet.
But in some cases it is possible that the unit
is not to condensate water evaporation,
then the internal water tank is full.
Follow the steps to drain water (see picture
15 on page 08):
• Unplug the air conditioner, disconnect
the exhaust hose from the back, and
move the conditioner to suitable drain
location or outdoors.
• Remove the base stopper from the base
restarts
(restart
Publicidad
