Craftsman 320.48298 Manual De Instrucciones página 10

4. Fig. 6
m
6_
7.
8_
g.
The length is shown in the
lower row of the screen in large
numerals, and the laser beam
switches off (Fig. 6).
To take a second measure-
ment, press the MEASURE key
to turn on the laser again, and
the first measurement data will
show in the upper row of the
screen (Fig. 7).
Aim at the new target.
Press the Measure key again to
take a second measurement.
The second length is shown
in the lower row of the screen,
and the laser beam switches
off (Fig. 8).
To take a new measurement,
follow steps 5 through 8, above.
Fig. 7
6.765 ft
€
I
I
6.765 ft
NOTE: If after choosing Area,
Volume or Pythagorean Theorem
measurement modes, you want to
go back to the single-measurement
mode, Press the CLR key to switch
back to single-measurement mode.
Area measurement
Press the "_" key to enter
area measurement mode; the
blinking line in "zC'EZT" icon
indicates the length to be
measured (Fig. 9).
Fig. 8
6.765 ft
2.24t ft
Fig. 9
i i i
48298 Manual Revised_07-O225 Page 10