Omega Lift Equipment 23212 Manual De Instrucciones página 3

MAINTENANCE
IMPORTANT : Use only a good grade hydraulic jack oil. Avoid mixing different types of fluid and NEVER use brake fluid, turbine oil, transmission
fluid, motor oil or glycerin. Improper fluid can cause premature damage of the jack and the potential for sudden and immediate loss of load. We
recommend Mobil DTE 13 or equivalent.
1. Adding Oil
23212 & 23222 & 24113 & 24213
1. Make sure that the saddle is fully lowered and that the pump piston is fully depressed.
2. Remove the oil filler screw on the right side and refill the oil until 5 mm to filler hole, reinstall the oil filler screw.
Changing Oil
For best performance and longest life, replace the complete fluid supply at least once a year.
23212 & 23222 & 24113 & 24213
1. Make sure that the saddle is fully lowered and that the pump piston is fully depressed.
2. Close the oil control valve.
3. Remove the oil filler screw on the right side , and drain the fluid into a suitable container.
4. Refill the oil until 5 mm to filler hole, reinstall the oil filler screw.
5. Open the oil control valve.
NOTE : Dispose of hydraulic fluid in accordance with local regulations.
3. Lubrication
1. A periodic coating of light lubricating oil to pivot points, axles and hinges will help to prevent rust and assure that wheels and pump assemblies move
freely.
2. When used on a daily basis, the air pump should be internally lubricated before each use. Use only good quality air tool lubricant. If no inline oiler is
used, pour a teaspoon of air tool oil into the inlet of the air control valve. Simply operate the jack using the air feature in order to fully distribute the
oil.
4. Cleaning
Periodically check the ram for signs of rust or corrosion. Clean as needed and wipe with an oily cloth.
NOTE : Never use sandpaper or abrasive material on these surfaces !
5. Storage
When not in use, store the jack with the pump piston and ram fully retracted.
WARNING
Study, understand, and follow all instructions provided with
and on this device. Do not exceed rated capacity. This is a
lifting device only. After lifting, immediately transfer the load
to appropriately rated vehicle stands. Never work on, under,
or around a load supported by this device. Use only on hard,
level surfaces capable of sustaining rated capacity loads. Do
not move or dolly loads with this device. Do not modify this
device. Failure to heed these markings may result in personal
injury and/or property damage.
3