Noaton CALLISTO 11055B Manual De Uso página 25

1 Safety instructions
Read the user manual carefully before using the device
Do not attempt to repair, disassemble or modify the appliance, or there may be
malfunction or damage.
The ceiling fan must be installed by a qualified electrician in compliance with local regulations onelectrical
installations.
Any work on the electrical connections must be carried out only after the electric power powering the
fan is turned off using a switch or home fuses.
The fan must be installed so that its blades are at least 230 cm above the ground and their ends at least
30 cm from the nearest obstacle or wall (the greater the distance, the better the airflow of the fan). The
base on which the mounting bracket is mounted with the supplied screws must be able to support a load
of at least 30 kg. The fan must not sway.
Do not plug the power of the fan to any dimmers, potentiometers, wall switches and similar devices, as
this may cause the fan to malfunction or damage its motor. The electrical connection must include
a circuit breaker in accordance with the decree on electrical installations, which ensures a single-phase
interruption connected directly to home fuses and must have gaps between all conductors providing total
disconnection according to Overvoltage category III. The fan must be connected to a protected circuit. Use
only the supplied remote control to turn the fan on and off.
Do not insert any objects into the blade rotation area that may collide with the blades. Such impact may
damage the blades and cause imbalance of the fan and its vibrations and increase the noise level.
After installation, check the tightness of the individual screws. Loose screws are one of the causes of
a noisy fan.
Due to the rotating motion of the fan, some connections may become loose over time. Therefore, check
all the screws and other connections at least twice a year and tighten them if necessary.
If the power cord is damaged, it must be replaced by a manufacturer, specialized service centre or other
qualified certified service in order to avoid any malfunction or health hazard.
The lighting of this fan must be replaced only by a manufacturer, specialized service centre or other
qualified certified service in order to avoid any malfunction or health hazard.
Note: Important warnings and instructions in this user manual do not cover all possible conditions and
situations that may arise. It is always necessary to use common sense, be cautious and anticipate any
possible situations that may arise.
Use the device at the specified voltage.
The fan is intended for indoor domestic use only. Do not use it for any other purposes.
Do not place the fan near heat-generating equipment or flammable and hazardous materials.
This appliance is not intended for use by persons (children) with reduced physical, sensory or mental
capabilities, or lack of experience or knowledge, unless they have been instructed in the safe use of this
device or are under the supervision of a person responsible for their safety.
EN
25
.