Publicidad
Idiomas disponibles
Idiomas disponibles
All illustrations in this manual are for illustrative purposes only. Your device may look slightly
Make sure that all accessories have been removed from the packaging before use.
ASSEMBLY AND INSTALLATION
Exhaust air
In cooling mode, the unit should be placed near a window or opening
to exhaust the warm exhaust air to the outside. Start by placing the
unit on a flat surface and make sure there is a minimum distance of 45
cm (18 inches) all around. There should also be an electrical outlet
nearby.
Take one side of the hose and extend it (see Figure 1), then screw it
to the hose inlet (see Figure 2).
Extend the other side of the hose and attach it to the hose outlet (see
Figure 3).
Install the hose connector on the unit (see Figure 4).
Attach the hose outlet to the window slide set and ensure an airtight
connection (see Figure 5 & 6).
This ensures that the mobile air conditioner works efficiently and that
the discharged warm air is properly directed outside.
Your window glider kit is designed for most vertical and horizontal
window applications, but can also be used with exterior blinds.
However, certain types of windows may require you to change some
aspects of the installation procedures. The window slider kit can be
fixed with screws.
If the window opening is shorter than the minimum length of
the window glider set, cut the end without the support short
enough to fit into the window opening. Never cut out the hole
in the window glider set.
NOTICE:
different.
NOTICE:
215
Pull the
Exhaust hose apart
1.
2.
3.
Insertion
4.
To adjust the length, cut on the
opposite side of the hole.
Publicidad
