Hotpoint Ariston KIC 630 B Manual De Instrucciones página 24

Installation
Before operating your new appliance please read this instruction
!
GB
booklet carefully. It contains important information concerning the
safe operation, installation and maintenance of the appliance.
! Please keep these operating instructions for future reference.
Pass them on to any new owners of the appliance.
Positioning
! Keep all packaging material out of the reach of children. It may
present a choking or suffocation hazard ( see Precautions and
tips ).
! The appliance must be installed by a qualified professional in
accordance with the instructions provided. Incorrect installation
may cause harm to people and animals or may damage property.
Built-in appliance
Use a suitable cabinet to ensure that the appliance functions
properly.
• The supporting surface must be heat-resistant up to a
temperature of approximately 100°C.
• If the appliance is to be installed above an oven, the oven
must be equipped with a forced ventilation cooling system.
• Avoid installing the hob above a dishwasher: if this cannot be
avoided, place a waterproof separation device between the
two appliances.
• Depending on the hob you want to install, the cabinet must
have the following dimensions ( see figure ):
V e n t i l a t i o n
To allow adequate ventilation and to avoid overheating of the surrounding
surfaces the hob should be positioned as follows:
• At a minimum distance of 40 mm from the back panel or any
other vertical surfaces.
• So that a minimum distance of 20 mm is maintained between
the installation cavity and the cabinet underneath.
• Kitchen cabinets adjacent to the appliance and taller than the
top of the hob must be at least 600 mm from the edge of the
hob.
F i x i n g
The appliance must be installed
surface.
Any deformities caused by improper fixing could affect the
features and operation of the hob.
24
on a perfectly level supporting
min. 20 mm
COMPARTMENT
min. 40 mm
min. 20 mm
FAN-ASSISTED
OVEN
min. 40 mm
FRONT SIDE
OF HOB
UNDERSIDE
OF HOB
SUPPORTING
SURFACE