Harman AKG HSD 171 Modo De Empleo página 29

Deactivating the
Microphone Muting
Function
HSC 171 HSC 271 HSD 171 HSD 271
Bass cut filter ON
Jumper in position 1
3
6) Push the pcb into the shell, replace and tighten the fixing screw (1), and
screw the cable bushing (2) onto the blue strain relief (5).
1) Disconnect the phantom power adapter from the mixer input.
2) Remove the fixing screw (1) from the phantom power adapter.
3) Unscrew the cable bushing (2).
4) Pull the pcb out of the shell WITH EXTRA CARE.
Microphone muting function: ON (a) and OFF (b)
5) Unsolder the green wire from the pcb and insulate the stripped end with
insulating tape.
6) Push the pcb into the shell, replace and tighten the fixing screw (1), and
screw the cable bushing (2) onto the blue strain relief (5).
Bass cut filter OFF
Jumper removed
4
Operating Notes
Jumper in position 2
3
29