Linea 2000 DOMO DO7107S Manual De Instrucciones página 35

4. When the temperature indicator goes out, the selected temperature has been reached.
You can now start ironing.
Caution: Never touch the hot soleplate!
STEAM IRONING
Caution: do not plug in the appliance yet at this point.
1. Grab the water tank of the steam generator by the handle and press the trigger on the
the handle to pull the water tank out of the generator. Open the filling cap and fill the
water tank with water. Make sure that you do not exceed the maximum level (1.8 L).
Close the filling cap after filling the water tank.
2. Place the water tank back into the steam generator. Caution: if the reservoir is not
replaced properly, the machine will not produce any steam.
3. Place the iron on the thermal insulation pads of the steam generator.
4. Plug in the generator. Set the temperature dial to the desired temperature, according to
the kind of fabric, and the temperature indicator will light up.
5. The water in the water reservoir will heat up and after
a few minutes the temperature light will go out. This
means that the steam generator has reached the correct
temperature. You can now press the steam button to
discharge steam.
Caution: the temperature button must be in the steam
area for this (indicated by
Between ironing, the iron may be placed on the base for
a short while.
6. Please note:
· Do not touch the hot sole of the iron!
· Never aim steam at people!
· The supply cable may heat up during a long ironing session.
· If the noise of the pump gets louder, the water reservoir most likely has to be filled. Make
sure there is always enough water in the reservoir, at least above the minimum level.
7. When finished with ironing, turn the temperature disc down to its minimum and remove
the plug from the mains. Place the iron on the thermal isolation cushions of the steam
generator and allow to it cool completely.
IRONING TIPS
· Always check first if there is a label on the garment with instructions for ironing. If this is
the case, then always follow these instructions.
· The iron heats up faster than it cools down. Therefore, always iron the garments that
require the lowest temperature first, like synthetic fabrics.
· If a fabric contains several types of fibres, always choose the lowest temperature to iron
the combination of these fibres.
www.domo-elektro.be
).
35
DO7107S