Publicidad
q
r
w
e
w
t
q
e
Basting
q Pattern:
w Presser foot:
e Thread tension:
r Feed dog:
t Foot pressure:
Attaching the darning foot
Raise the needle.
Remove the foot holder by loosening the thumb screw.
Attach the darning foot on the presser bar putting the pin
on the needle clamp. Tighten the thumbscrew firmly with a
r
large screwdriver.
q Foot holder
w Thumb screw
e Pin
r Needle clamp
To sew
Lower the feed dog.
Set the thread tension dial between 1 and 3.
Put some fabric under the foot and press up/down needle
position button twice to bring the needle thread down
through the hole in the foot.
Pull the fabric and thread to the rear. Lower the presser
foot.
Press down the foot control. The machine stops after each
stitch.
Move the fabric to where you want the next stitch.
Repeat steps to to sew. After finishing sewing, pull the
threads and fabric to the rear side.
* After sewing, reset tension to "AUTO". Return feed dog
lever to raised position. Feed dog will rise when sewing
resumes.
66
#27 (mode 2)
Darning foot P
1–3
Lowered
1
Publicidad
