Registering To The Preset Dial Number List; Dialing By Using The Phone Book; Dialing By Using The Outgoing Call List - Kenwood KCA-BT100 Manual De Instrucciones

Dialing Method
Registering to the Preset Dial Number
List
You can register up to 3 phone numbers for quick
dialing.
1
Enter the phone number you wish to register
Enter the phone number with reference to the
following:
- <Making a Call by Entering a Phone Number>
(page 7)
- <Dialing by Using the Phone Book> (page 8)
- <Dialing by Using the Outgoing Call List> (page
8)
- <Dialing by Using the Incoming Call List> (page 9)
2
Select the button you wish to register
Press the [1] – [3] button for at least 2 seconds.
For the Audio receiver with Multi-function Key System:
1 Press the [NEXT] button.
Select the key function section.
2 Press the [1] ("1"/ "MEM.1") – [3] ("3"/
"MEM.3") button for at least 2 seconds.
"Memory" or "MEMORY" display blinks 1 time.
3
Exit the dialing method selection mode
Press the [ATT] button for at least 1 second.

Dialing by Using the Phone Book

You can dial by using the downloaded Phone Book.
1
Enter the Phone Book mode
Select the "INITIAL", "PH-BOOK1", "PH.BOOK", or "PH-
BOOK2" display.
Refer to <Selecting the Dialing Mode> (page 7).
If you have selected, "PH.BOOK" or "PH-BOOK2",
proceed to step 4.
For the Audio receiver with Multi-function Key System:
Press the [2] ("PHBK") button.
Pressing this button toggles between the
following search methods:
Display Search method
"INITIAL"/ Search by the initial.
"PH-BOOK1"
"PH.BOOK"/ Search in the alphabetical order.
"PH-BOOK2" Proceed to step 4.
8
|
English
(For Audio receiver)
2
Select the initial to be searched for
Push the Control knob towards [4], [¢],
[FM] or [AM].
Move the cursor to the initial to be searched for.
Knob Operation
[4]/ [¢] Move to the next character.
[FM]/ [AM] Move to the next row.
3
Determine the selected initial
Press the Control knob ([38]) for at least 1
second.
4
Select the name
Push the Control knob towards [FM], [AM],
[4] or [¢].
Select the name.
Knob Operation
[FM]/ [AM] Change the name.
[4]/ [¢] Change the initial.
5
Make a call
Press the Control knob ([38]) for at least 1
second.
"CALL" or "Call" is displayed.
• To use the Phone Book, it must have been downloaded
from the cell-phone. For details, see <Downloading the
Phone Book> (page 5).
• Initials including no corresponding name will not be
displayed.
• On the control unit that displays three rows, the name in
the middle row is the selected one.
• During search, a non-accent character such as "u" is
searched for instead of an accent character such as "ü".
• Characters that the control unit cannot display are
searched for in the order in which they were registered
to the Phone Book.
Dialing by Using the Outgoing Call
List
You can dial by using the outgoing call list. Up
to ten phone numbers of the originated calls are
recorded in the outgoing call list.
1
Enter the outgoing call list mode
Select the "OUT" or "OUT-CALL" display.
Refer to <Selecting the Dialing Mode> (page 7).