Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 7
Plug the base into a power source. A surge
protector is strongly recommended.
STEP 8
Install (2) AAA batteries in remote
control. Quickly test functions to verify
proper setup before placing mattress on
base. Return the base to a flat position
before placing the mattress on top.
STEP
9
To install the mattress retainer bar, insert each end
of the bar into the holes at the foot of the platform.
STEP
10
Raise head of the base to maximum articulation.
Confirm that the LED on the black Sleeptracker
processor is blinking green. This may take up to
90 seconds. This indicates that the processor is
powered up and ready to connect to a WiFi network.
The Bluetooth
word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Tempur
®
Sealy International, Inc. is under license. Other trademarks and trade names are those of their respective owners.
STEP
11
Have the customer scan the QR code on the remote
control packaging or on the rear side label of the
remote control to set up the Tempur
App.
Information can also be found at :
https://www.sleeptracker.com/getapp/tempur
TBD
STEP
12
Give remote and Remote - Quick Use Guide to
customer. Ask them to read the Warning and Use
Instructions to see if they have any questions. Advise
them to store the Remote - Quick Use Guide for
future reference.
Test all functions on the base to ensure proper setup. For
more information please see Owner's Manual
For Tempur-Pedic
U.S. 1-844-309-3597 | Canada: 1-800-887-4321
or
customer service call:
®
México: 01-722-273-1810
Sleeptracker-AI
®
®
Publicidad
