The Aspect Select Menu - Sony VPL-W400Q Manual De Instrucciones

The ASPECT SELECT Menu

The ASPECT SELECT menu is used to set the picture
mode.
A U T O W I D E : O F F
INPUT
SELECT
A S P E C T : S U B T I T L E
MEMORY
SELECT
V S C R O L L : 0
T I T L E A R E A : 4
ASPECT
SELECT
SET
SETTING
INPUT
INFO.
Operation
When changing the adjustment level:
1. Select an item.
Use the V or the v key on the control panel to select
the item, then press the b or the ENTER key.
On the Remote Commander, move the joy stick up or
down to select the item, then move it to the right or
press the ENTER key.
The selected item is dislayed at the bottom.
V S C R O L L : + 2 0
2. Change the adjustment level.
To increase the number, press the V or the b key.
On the Remote Commander, move the joy stick up or
to the right.
To decrease the number, press the v or the B key.
On the Remote Commander, move the joy stick down
or to the left.
3. Press the ENTER key to restore the original
screen.
The original screen is restored.
24
(EN)
V I D E O
SEL: EXIT: MENU
When changing the setting:
1. Select an item.
Use the V or the v key on the control panel to select
the item, then press the b or the ENTER key.
On the Remote Commander, move the joy stick up or
down to select the item, then move it to the right or
press the ENTER key.
The pop-up menu for the selected item appears.
V I D E O
A U T O W I D E : O N
INPUT
SELECT
A S P E C T : S U B O F F L E
MEMORY
SELECT
V S C R O L L : + 2 0
T I T L E A R E A : 0
ASPECT
SELECT
SET
SETTING
SEL: SET: ENTER RESET: RESET
INPUT
INFO.
EXIT: MENU
2. Change the setting.
Press the V or the v key on the control panel.
On the Remote Commander, move the joy stick up or
down.
3. Press the ENTER or the B key on the
control panel to restore the original screen.
On the Remote Commander, press the ENTER key or
move the joy stick to the left.
AUTO WIDE
Selects the AUTO WIDE mode.
V I D E O
A U T O W I D E : O N
INPUT
SELECT A S P E C T : S U B O F F L E
MEMORY
SELECT V S C R O L L : + 2 0
T I T L E A R E A : 0
ASPECT
SELECT
SET
SETTING
SEL: SET: ENTER RESET: RESET
INPUT
INFO.
EXIT: MENU
ON: The picture automatically switches to wide-
screen mode (ZOOM or SUB TITLE) when a
letter box signal is received.
When an ID-1 signal is received, the picture is
automatically set to FULL or ZOOM.
OFF: The AUTO WIDE function does not work.
Note
The AUTO WIDE function may not work correctly
depending on a video signal. In this case, set the
AUTO WIDE function to OFF.