GE PVM1790 Instrucciones De Instalación página 17

Installation Instructions
[_ Roll the blower unit 90° so that fan blade openings
are facing out the back of the oven.
Before Rollin_
Back of
Oven
After Rolling
Backof
Oven
[_ Locate the two "knockout" plates, on the rear oven
panel, near the top of the oven.
Using tin snips, carefully cut the web area from the
two holes side-by-side (that secure the knockouts to
the oven). Cut all four webs on both rear knockouts;
this will allow the ventilation fan airflow to exhaust
out the rear of the oven.
A,--^, ,-r,,-,t,,
Jll!_,l'_U/I _1_1 : Be sure to trim the sharp
edges from the openings after removing the
knockout plates.
Oven Rear Panel
__ Snip all 4 webs
oneachknockout
__ panel a ndremove
_.____ / themetalknockouts
_ __z / forrearairflow.
[_ Place the blower unit buck into the opening.
AFTER: F anBlade -End A
Openings Facing
i i f
EndB@_
WA RNI NG: Risk of e lectric shock
can cause injury or death. Do not pull or stretch
the blower unit wiring, make sure the wires are
not pinched..
NOTE:The blower unit exhaust openings should
match exhaust openings on rear of microwave oven.
%
Replace the blower plate in the same position
as before with the screws.
_ Blower Plate Screws
Blower Plate
_i <[_>_'_ Back of Oven
J ...... l
[_ Insert the tabs on each side of the dumper
into the holes at the inside rear of the adaptor.
_ Exhaust
Adaptor
[_ Attach the exhaust adaptor to the rear of the oven
by sliding it into the guides at the top center of the
back of the oven.
Exhaust Ada per
(hinge sideup)
Slideexhaust _x,
adaptor i nto
guides on Screws
oven rear.
Backof Oven
Locking
Tabs Guides
Push in securely until it is in the lower locking tubs.
Take care to assure the dumper hinge is installed
so that it is at the top and that the dumper swings
freely.
[] Secure the exhaust adaptor to the oven with
the two bronze metal screws provided.
17