GE PVM1790 Instrucciones De Instalación página 20

Installation Instructions
ADAPTING BLOWER
FOR RECIRCULATION
NOTE:The exhaust adaptor with damper is not
needed for recirculating models. You may want
to save them for possible future use.
[_3 Remove and save screws that hold blower plate
to the oven.
7 _ Blower Plate Screws
_-_ BackofOven
[_3 Slide the blower plate from under its retaining
flange and lift it off. Remove and save screw that
holds the blower motor to oven.
Retaining __
Flange _ J "_4__---..._ D,r
'_f _ Blower P late
- _ _'_ ...... Blower M otor
Screw
[_3 Carefully pull out the blower unit. The wires
will extend far enough to allow you to adjust
the blower unit.
[_ Roll the blower unit 90 ° so that fan blade openings
are facing toward the front of the oven.
BEFORE: Fan Blade
Openings Facing Up
Roll_
J
AFTER: Fan Blade
Forward
NOTE: Hake sure wires remain routed in the grooves
of the motor frame.
2O