Levenhuk Wezzer PRO LP380 Guia Del Usuario página 10

To establish a connection with the multisensor, move the console to a distance of 1.5 to 3m and wait a few minutes
for synchronization.
Once synchronized, simulate wind and rain by rotating the wind sensor cups and dripping water into the rain gauge.
After 15 minutes, install the multisensor and console in their permanent locations. Follow the recommendations
for installing the multisensor and improving wireless communication.
The console should show data for all sections. Wind and rain readings will be zero until the sensors start receiving data.
Vertical stand
The console includes a vertical stand. The console display is best viewed at a 20–30° angle.
Initial display console setup
Connect the AC adapter to power up the display console.
The device will display the software version number for 2 seconds.
The console will then turn on all LCD segments for 3 seconds and begin recording the external channel for 3 minutes.
Display Console Button Functions
SET (Setup)
Press: View MAC address.
Hold: Enter setup mode.
TEMP (Temperature)
Press: View wind chill, heat index, dew point.
RAIN
Press: View precipitation intensity, daily, weekly, monthly, annual and total data.
Hold for 2 seconds: Reset current precipitation data.
WIND/+
Press: View wind speed/gusts and direction.
PRESSURE/–
Press: View absolute pressure (average for 12, 24, 48, 72 hours).
Hold for 2 seconds: View absolute and relative pressure.
10