Publicidad
Idiomas disponibles
Idiomas disponibles
Calibration mode
Hold TEMP (Temperature) and MAX/MIN together for 5 seconds to enter calibration mode.
WIND/+ and PRESSURE/–: Adjust values.
SET: Confirm and move to the next item.
ALARM: Reset the configured values.
LIGHT/SNOOZE: Output.
Calibration procedure: 1) room temperature offset; 2) shift in indoor humidity; 3) outdoor temperature shift; 4) shift in
humidity outdoors; 5) absolute pressure shift; 6) shift in wind direction; 7) setting the wind speed coefficient; 8) setting
the precipitation coefficient.
Additional features
•
Reset to factory settings / Clear memory
Power down the console, remove the batteries, and disconnect the DC adapter. Wait, then reconnect the DC adapter.
Wait for all segments to appear on the screen.
Hold WIND/+ and PRESSURE/– simultaneously until the console power-up sequence is completed (about 5 seconds).
Replace the batteries.
•
Registering a new transmitter
Hold LIGHT/SNOOZE for 5 seconds and the console will re-register the remote sensor.
•
Backlight operation
With the AC adapter, the backlight can stay on constantly.
Press LIGHT/SNOOZE to adjust brightness between high, low, and off.
Without the adapter, the console goes into sleep mode and does not send data to the Internet if no button is pressed
for 15 seconds. Hold LIGHT/SNOOZE or connect the DC adapter to wake up.
Trend arrow indicators
The temperature, humidity and pressure change indicator shows the change in these values over a three-hour update
period.
•
Value rising:
•
Value falling:
•
Value steady:
Wireless signal strength indicator
The wireless signal strength indicator shows the reception quality. If the signal is not lost, the indicator displays 5 bars.
If the signal is lost once, 4 bars are displayed.
Weather forecast
Changes in atmospheric pressure are used to predict weather conditions for the next 6 hours. The weather station requires
at least 1 month to adapt to barometric pressure.
1
One-time signal loss
2
13
3
Publicidad
