Levenhuk Wezzer PRO LP380 Guia Del Usuario página 12

Moon phase
Press SET 16 times to select Northern or Southern Hemisphere.
New Moon
Full Moon
Alarm mode
Press and release ALARM to display the upper alarm thresholds.
Press ALARM again to show the lower alarm thresholds.
In Alarm mode, press RAIN to display precipitation data and WIND/+ to display wind data.
Press ALARM or LIGHT/SNOOZE to return to normal mode.
Alarm mode setup
Press ALARM for 2 seconds to enter alarm mode setup. Press WIND/+ or PRESSURE/– to turn alerts on/off and adjust
alert values. Press SET to confirm and move to the next item. Press ALARM to turn the alarm on/off. When an alert is
triggered, the source icons will flash.
Procedure for setting up alerts: setting the time, setting the upper/lower thresholds of temperature and humidity indoors,
setting the upper/lower thresholds of temperature and humidity outdoors, setting the thresholds for wind, gusts of wind,
amount of precipitation.
Max/Min mode
Press and release MAX/MIN to display maximum/minimum data. In this mode, use the following buttons:
TEMP (Temperature): Maximum values for perceived temperature, heat index, and dew point.
RAIN: Maximum rainfall intensity values for the day, week, or month.
WIND/+: Maximum wind and gust values.
PRESSURE/– (2 sec): Maximum absolute and relative pressure values.
Press again to display minimum data.
TEMP (Temperature): Minimum wind chill and dew point.
PRESSURE/– (2 sec): Minimum absolute and relative pressure values.
Hold MAX/MIN for 2 seconds to reset all maximum or minimum values.
To return to normal mode, press LIGHT/SNOOZE or MAX/MIN three times.
Waxing Crescent
Waning Gibbous
12
First quarter
Last quarter
Waxing Gibbous
Waning Crescent