Levenhuk Wezzer PRO LP380 Guia Del Usuario página 9

ATTENTION! If the LED does not light up or stays on, make sure the batteries are inserted properly and
the device is reset correctly. Incorrect installation of batteries may cause permanent damage to the outdoor
sensor.
ATTENTION! In cold climates, we recommend using 1.5V lithium batteries. Alkaline batteries are suitable for
most climates. We do not recommend using rechargeable batteries due to their low voltage, instability
in a wide temperature range, and short service life, which leads to poor signal reception.
Mounting the assembled multisensor
Attach the multisensor to the prepared 2.5–5.0cm diameter pipe using U-bolts.
Align the multisensor in the North direction by rotating it on the mounting pipe. The NORTH arrow, located on the top
of the multisensor next to the solar panel (7), should point due north. Use a compass for fine adjustments.
Once correctly oriented, tighten the bolts.
ATTENTION! Use the bubble level (6) next to the rain gauge (5) to ensure the multisensor is level.
Reset button and transmitter LED
If the multisensor is not transmitting data, perform a reset. Press and hold RESET for 3 seconds.
Remove the batteries and wait 1 minute with the solar panel closed. Insert the batteries and re-sync with the console by
turning the console off and on. Stay about 3m away from the multisensor.
Recommendations for improving wireless connectivity
To avoid radio frequency interference, we recommend that you adhere to the following conditions.
• Place the console several meters away from computer monitors and TVs.
• If you have devices on the 433MHz frequency and are experiencing intermittent connectivity, please unplug them
to troubleshoot.
• The maximum range of the device is 100m without, and 30m with obstacles.
• The radio signal does not pass through metal. With metal siding, place the sensor and console so that there is
a window between them.
Glass (untreated)
Display console
Connect the DC adapter (5V) to the port on the back of the console.
Insert 3 AAA batteries into the display console (for backup power). The backlight will work for 5 seconds if only the backup
power is used. Constant backlight is only available when using the adapter. If your console is powered by batteries only,
press LIGHT/SNOOZE to turn on the LCD backlight before using other buttons.
Table of materials and their effect on radio signal transmission loss
Material
Plastic
Wood
Brick
Concrete
Metal
Radio signal transmission loss
9
5–15%
10–15%
10–40%
10–40%
40–80%
90–100%