Publicidad
Idiomas disponibles
Idiomas disponibles
3. Make sure that the muffler is correctly attached to
the product. Tighten the screws to 8-12 Nm.
4. Examine the spark arrester screen, do a visual
check.
a) Replace the spark arrester screen if it is
damaged.
b) Clean the spark arrester screen if it is blocked.
To do maintenance of the muffler on
Refer to
page 15 for more information.
Vibration damping system
The product has a vibration damping system that
decreases vibrations and makes operation easier.
Examine the vibration damping system and make sure
that it is not damaged. Make sure that the vibration
damping system is attached correctly.
Air filter
Do not use the product without an air filter or if the air
filter is damaged or has a deformation.
8
x2
Stop switch
Use the stop switch to stop the engine. Make sure that
the engine stops fully.
Harness safety
Always use the harness when you operate the product.
If you do not use the harness, you cannot operate the
product safely. This can result in injury to you or other
persons. Make sure that the straps are attached and
correctly adjusted. There is a risk that an straps that are
loose can go into the fan of the product.
Fuel safety
WARNING:
instructions that follow before you use the
product.
•
Do not mix the fuel indoor or near a heat source.
•
Do not start the product if there is fuel or engine oil
on the product. Remove the unwanted fuel/oil and let
the product dry. Remove unwanted fuel from the
product.
•
If you spill fuel on your clothing, change clothing
immediately.
•
Do not get fuel on your body, it can cause injury. If
you get fuel on your body, use a soap and water to
remove the fuel.
•
Do not start the engine if you spill oil or fuel on the
product or on your body.
Read the warning
1654 - 002 - 19.04.2021
Publicidad
