Trevi XF 470 KB Guia Del Usuario página 14

IMPORTANT
- Dispose of used batteries in accordance with the recycling regulations in
your area.
- Danger of explosion if battery is incorrectly replaced.
- Replace only with the same or equivalent type.
- If the remote control is not used for a long time, the battery may leak and
damage the remote control, replace it with a new one if this occurs.
- DO NOT short-circuit the batteries or throw them into water, general garbage
or fire.
CHARGING THE BATTERY
1. With the appliance off, connect the power supply cable to the charging port
type-C(5) on the device. Connect the cable to a 5V
supplied) and the latter to a mains socket;
2. The red LED indicator(6) will light up;
3. Once charging is complete, the red LED indicator (6) will turn off.
With low battery, the last segment of the battery icon on the display will flash for
a certain time, then the device will switch off automatically.
Note: For a good battery life, it is recommended to keep the device off during the
charging.
Unless otherwise specified, the commands described below apply to both the
unit and the remote control.
ON/ OFF
- Use the On/Off switch(16) to turn the appliance On and Off (position "I" On,
position "0" Off ).
- Press the button
mode; press it again to switch On the unit.
VOLUME/ MUTE/ TONE/ MIC VOLUME/ ECHO/ EQ ADJUSTMENT
1. Rotate the Volume knob (15) clockwise/counterclockwise to increase/decrease
the volume of the unit. Press the button
mute the device, press it again to return to normal listening;
2. Press
crophone volume and echo effect;
3. Press the EQ(25) button on the remote control several times to choose the
best audio dynamics from the preset ones: POP, CLAS, COU, NOR,
DISCO-LIGHT
VOLUME +
Press the button
will be distinguished on the display with: Led1, Led2, Led3, Led4, Led5, Led6, OFF.
Select "OFF" to turn off the front Led lighting completely.
14
(17) on the remote control to put the unit in stand-by
LED
(14) button and rotate the knob(15) to adjust the treble, bass, mi-
(8) several times, to change the Disco-Light lighting effects, they
MUNE
(27) on the remote control to
2A power supply (not
ROCK.