Publicidad
Idiomas disponibles
Idiomas disponibles
To Set:
The microwave oven must be in standby.
1. Press Timer/Clock button for 3 seconds to enter clock
setting. It will also appear every time the product is plugged
into the power source, or power is back after a power fail.
2. Press "+/-" button to set the hour.
3. Press Start button to confirm.
4. Press "+/-" button to set the minute.
5. Press Start button to confirm the setting.
Tones ON/OFF
This function allows the user to activate/deactivate all the
sounds played by the appliances, includes button press,
warnings, alarm, even end audio feedback.
Press Steam Clean button and hold for 5 seconds to put into
mute, hold the button again for 5 seconds to turn on the sound.
"This function can operate at any time" in Tones on/off function.
To use Sensor Menu
(Reheat, Cook Menu)
1. Place food on the turn table and close the door.
2. Touch the desired menu control.
3. Touch Start, the running segment animation will appear
in the display. The microwave oven will start and sensor
cooking will begin.
The running segment will remain in the display until the
sensor has determined the remaining cook time.
4. When the cycle end, "END" will appear in the display and the
end-of-cycle tones will sound.
5. Touch Stop/Unlock or open the door to clear the display.
(NOTE: Sauce, Soup and Beverage in Reheat Menu, Potato in
Cook Menu without using Sensor cooking).
Clock
To Set:
1. Press Timer/Clock button.
2. Press "+/-" button to enter desired time.
3. Press Start button. When the set time ends, the
end-of-timer.
4. When the Timer countdown is achieve in the display, tone
will sound. Press Stop/Unlock to stop the timer.
NOTE: The Timer does not start or stop the microwave oven.
The function can be set only in Standby mode.
Cooking End
When the cooking is finished, the display will show the text
"END". A reminder acoustic beep will signal.
NOTE: If the cooking time is more than 2 minutes, after cooking
end, the cooling fan and Forced Convection fan are ON for
3 minutes, cavity lamp is OFF, which is helping to cool down the
component to have better quality.
1. After the Cooking End, If you press the Stop/Unlock button,
takes out the food and closes the door again, the interface
will display the clock, it will switch to 1-step door opening.
2. If you will not remove the food within 30 minutes, it will
consistently display "END" for 30 minutes, and automatically
return to standby mode and unlock after 30 minutes and it
will switch to 1-step door opening.
Timer
9
Publicidad
