Publicidad
Idiomas disponibles
Idiomas disponibles
○ Some cigarette lighter sockets only supply power
when the ignition is switched on or the vehicle engine
is switched on.
○ When used with an in-vehicle power supply, the
volume of air blown is lower compared to when used
with a battery.
USE
WARNING
● Operate the tool only under supervision.
Excessive pressure can burst the object being
inflated and cause injury and property damage.
● During use, pay attention to the pressure gauge
on the tool body and the condition of the object
being inflated, and stop the tool immediately if
you feel that anything is abnormal.
NOTE
The LED light and display will turn off automatically
after 5 minutes pass while the power is on, the motor
is not started, and no other buttons are pressed.
1. Inflate using high-pressure hose
CAUTION
In High-Pressure mode, the product can be
operated continuously for a maximum of
5 minutes. After using the product for 5 minutes,
stop using it for 10 minutes and allow it to cool.
(1) Unwind the high-pressure hose.
(2) Screw the high-pressure hose onto the valve of the
object to be inflated. Screw one of the adapters, onto
the high-pressure hose and then attach it to the valve
of the object to be inflated.
Presta Valve Adapter
Shrader Valve Adapter
High-Pressure hose
Ball Needle
High Pressure
Tapered Nozzle
Fig. 9
WARNING
Ensure that the attached adapter is screwed in
firmly before starting the inflator.
(3) Switching on the tool: Press the power button. The
display is on.
Power button
Mode button
+/- button
(4) Select High-Pressure mode by pressing mode button.
(5) Select the required tool of pressure (PSI / BAR / kPa)
by pressing the unit button.
(6) Set the required pressure in the display by pressing
the +/- button.
WARNING
The set pressure must not be higher than the
maximum permissible pressure of the object to
be inflated. It may otherwise burst and cause
injuries and property damage.
(7) Starting the inflation process: Press the start/stop
button. The pressure reaches is shown on the
display. The inflation process stops automatically
when the set pressure is reached. By pressing the
start/stop button the inflation process can be
interrupted at any time.
(8) Switching off the tool: Press the power button. The
display goes off.
(9) Remove the high-pressure hose from the object to be
inflated. If required, unscrew the adapter from the
high-pressure hose and store it in the storage. Wind
the high-pressure hose at the tool and clip it in place.
2. Inflating / deflating with the High-Volume hose
(1) Remove the high-volume hose from the tool and ...
English
Display
Start/stop button
Unit button
Fig. 10
15
Publicidad
