Publicidad
Idiomas disponibles
Idiomas disponibles
Westward Operating Instructions and Parts Manual
28. Assemble a cotter pin to the inside hole in an axle spindle. Place a Ø20 Flat Washer (R), a wheel (valve stem
facing out) and another Ø20 Flat Washer (R) onto the axle spindle. Assemble a cotter pin (O) to the end hole in
the axle. Repeat on other side. See Figure 12. Note: Prevent the axle spindle from pivoting downward until the
wheel is secures to it by the outer cotter pin.
29. Assemble a hub cap over the Ø20 Flat Washer (R) on each wheel. See Figure 12.
30. To lower the cart onto wheel chocks as shown in Figure 13. Get the assistance of another person to help you
lower the cart onto ground.
2000LB STEEL DUMP CART
FIGURE 12
FIGURE 13
11
46V232
Publicidad
