Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
20. Attaching the Side/Front Panel Assemblies
• Align the pre-installed hardware on the edges of
the left side assembly (Left Side Panel (Q) and
Left Lower Front Panel (P)) with the pre-drilled
holes on the underside of the Fixed Shelf (N) to
join the left side assembly with the upper
assembly.
• Secure the main assembly to the fireplace
surround by tightening the hardware with a
Phillips screwdriver as shown.
• Repeat these steps for the right side assembly
(Right Side Panel (S) and Right Lower Front
Panel (R)).
21. Attaching the Wire Clips
• Insert Wire Clips (UU) into pre-drilled holes in
the rail of the Right Surround Panel (V), pushing
them in by hand.
Hardware Used
Wire Clips
UU
22. Assembling the Inner Surround Panels
• Align pre-drilled holes at the top edges of Left
Surround Panel (T) and Right Surround Panel
(V) with the pre-installed hardware on the Upper
Surround Panel (U). Push together.
• Locate the pre-attached metal brackets found on
the Left and Right Surround Panels (T and V) and
rotate to span across the edges to the Upper
Surround Panel (U).
• Secure each bracket across each joint with a
Screw (TT) and Phillips screwdriver.
Hardware Used
Ø3x12mm
TT
Screw
28WM373 REV2.0
x3
x2
16
20
Q
N
21
V
22
U
V
S
T
Publicidad
