Publicidad
Idiomas disponibles
Idiomas disponibles
Care and Cleaning
Proper
care and cleaning
are important
so your range
will give you efficient
and satisfactmy
service. Follow
these directions
carefully
in caring fm it to help assure
safe and proper
maintenance.
BE SURE ELECTRICAL
POWER IS
DISCONNECTED
BEFORE CLEANING
ANY PART OF YOUR RANGE.
Sealed
Burner
Assemblies
(on some models)
CAUTION:
DO NOT OPERATE THE BURNER
WITHOUT
ALL BURNER
PARTS AND DRIP
PANS (IF SO EQUIPPED)
IN PLACE.
Grate
Burner
cap
Drip pan (on some models)
_
Burner head
Turn all controls
off before removing burner parts
and drip pans (if so equipped).
The burner grates, caps, heads and drip pans (if so
equipped)
can be lifted off, making them easy to clean.
The electrode of the
_\
_
spark igniter is exposed
r_
_r_..d-ia- Electrode
when the burner head
\_
_ _
is removed. When one
burner is turned to LITE, all the burners spark.
Do not attempt to disassemble or clean around
any burner while another burner is on. An electric
shock may result, which could cause you to knock
over hot cookware_
Burner
Heads
(on sealed burners only)
NOTE:
Before
removing
the burner
heads
and caps,
remember'
their size and location.
Replace
them
in
the same location
after cleaning.
For proper
ignition,
make sure the small
hole in the section
that fits over the
electrode is kept
open. A sewing
needle or wire twist
tie works well to unclog it.
The slits in the burner heads of}our
range must be
kept dean at all times for an even, unhampered
flame.
"You should clean the surface burners routinely, especially
after bad spillovers, which could clog these openings.
To remove burned-on
food, soak the burner heads in
a solution of mild liquid detergent
and hot water for
20-30 minutes. For more stubborn
stains, use a
toothbrush°
Before putting
the burner
head back, shake out
excess water and then dry it thoroughly
by setting it in
a warm oven for 30 minutes.
Replace the burner
heads and caps.
Make sure that the
heads and caps are
replaced on the
correct size burner.
There is one small,
8 Aftercleaning,make
2 medium
and one
sure the slot in the
burner head is positioned
large
cap.
over the electrode.
NOTE:
On some models the heads
and caps are all the same size and can be
used in any of the 4 needed locations.
(continued next page)
27
Publicidad
