Makita RP1100 Manual De Instrucciones página 7

4
1
2
3
1. Workpiece
2. Bit revolving direction
3. View from the top of the tool
4. Feed direction
001984
NOTE:
Make sure that the tool raises automatically when
•
the lock lever is loosened. The position of the bit
must be higher than the tool base when not
operating.
Moving the tool forward too fast may cause a poor
•
quality of cut, or damage to the bit or motor.
Moving the tool forward too slowly may burn and
mar the cut. The proper feed rate will depend on
the bit size, the kind of workpiece and depth of cut.
Before beginning the cut on the actual workpiece,
it is advisable to make a sample cut on a piece of
scrap lumber. This will show exactly how the cut
will look as well as enable you to check
dimensions.
When using the straight guide, be sure to install it
•
on the right side in the feed direction. This will help
to keep it flush with the side of the workpiece.
2
1
001985
Straight guide (optional accessory)
015278
The straight guide is effectively used for straight cuts
when chamfering or grooving.
2
4
1. Feed direction
3
2. Bit revolving
direction
3. Workpiece
4. Straight guide
4
1. Hex socket
bolts
1
2. Straight guide
2
To install the straight guide, insert the guide bars into
the holes in the tool base. Adjust the distance between
the bit and the straight guide. At the desired distance,
tighten the hex socket bolts to secure the straight guide
in place.
When cutting, move the tool with the straight guide flush
with the side of the workpiece.
015279
If the distance between the side of the workpiece and
the cutting position is too wide for the straight guide, or
if the side of the workpiece is not straight, the straight
guide cannot be used. In this case, firmly clamp a
straight board to the workpiece and use it as a guide
against the base. Feed the tool in the direction of the
arrow.
015280
Templet guide (optional accessory)
015281
The templet guide provides a sleeve through which the
bit passes, allowing use of the tool with templet patterns.
To install the templet guide, insert the templet guide in
center hole in the base plate and secure in place with
the lock nut.
7