Publicidad
Idiomas disponibles
Idiomas disponibles
Note: The picture is for reference only. The
content may vary depending on the model.
1.
Front grille
2.
Front mounting nut.
3.
Lock.
4.
Blades.
5.
Back mounting nut.
6.
Rear grille.
7.
Motor shaft.
8.
Fan head.
9.
Adjustable head angle Shaft
10. Fan housing (control panel).
11. Fixing screw.
12. Inner tube.
13. Height Adjustment Collar.
14. Outer tube.
15. Base.
16. Screw type "L" (for base mounting).
17. Remote control.
You can check the product features in table
01 on page 08.
ASSEMBLY AND INSTALLATION
Before unpacking the product, memorize
the position of each accessory in case you
need to repack it in the future.
The fan is packed with the grilles removed.
You must place the grilles before operating
the fan.
Warning: Never operate the fan without its
base or other parts.
Operate the fan only in an upright position;
any other position could create a dangerous
situation.
Assemble the base and other parts of the
appliance considering the following notes.
Note: the images are for guidance only and
should be used to support the installation.
See pictures 02, 03 and 04 on page 05.
• Unpack and take out every part of the
fan.
• Unroll the Screw type "L" (16) from the
outer tube. (14)
• Insert the outer tube (14) in the base and
adjust the Screw type "L" (15)
• Unroll the height Adjustment Collar (13)
and adjust the inner tube (12) until you
get the desired height. (Note: The inner
tube is located inside the outer tube,
Take it out gently until it is displaced)
• To include the fan head (8), place gently
the fixing screw (11) in it.
• Insert the fan head (8) into the inner
tube (12) and set by using the fixing
srew (11).
• Unscrew the two plastic mounting
nuts from the motor shaft (7), as they
are fixed at the factory, the one on the
blades (2) clockwise and the one on the
rear grille (4) anti-clockwise.
• Adjust the rear grille (6) to the fan head
(8); get rid of the plastic lining of the
motor shaft. Next, use the mounting nut
(2) to fix the blades (4).
• Place the front grill (1) until it tightsto
the rear grill (5).
• Use the lock all around the
to attach them, tighten it until it is
completely secured.
USING THE APPLIANCE
This device is easy to use and does not
require much knowledge. However, we
advise you to familiarize yourself with the
instructions below.
(
Control panel
see picture 05 on page 06)
18. ON/SPEED
19. MODE
20. TIMER
21. SWING
22. OFF
• Turn on the fan by pressing "ON/SPEED"
(18), either on the control panel or from
the remote control. It will start on a low
speed, on the display screen wil appear
"LOW", to increase the speeds press
repeatedly "ON/SPEED", from "LOW" to
EN
grilles
23
Publicidad
