Peavey SMR 6 Guía De Operación página 3

ENGLISH
CLIP LED (1)
This LED will illuminate when the signal in the channel reaches clipping.
LEVEL CONTROL (2)
Determines the level of the channel in the main mix. This control should be operated near the mid-point
of its travel (5), to assure an optimum balance between channel noise and headroom.
LOW EQ (3)
An active tone control (shelving type, +15 dB) that varies the low frequency boost or cut.
MID EQ (4)
An active tone control (peak/notch, +12 dB) that adjusts the mid frequency range.
HIGH EQ (5)
An active tone control (shelving type, +15 dB) that varies the high frequency boost or cut.
LED BAR (6)
A five segment LED array used to visually indicate the level of signal at the Master output. The top (red)
LED is a clip indicator for the Master output.
METER ADJUST (7)
Used to set the level of signal that is seen by the LED meter.
MASTER OUTPUT (8)
Controls the overall volume level of the Master Output. This level can be seen on the LED meter.
AUX OUTPUT (9)
Controls the overall volume level of the Aux Output.
POWER LED (10)
Indicates that AC mains power or DC power is connected and power switch is in the "on" position.
POWER SWITCH (1)
Depress the switch to the "on" position. The red pilot light (LED) will illuminate, indicating power is being
supplicd to the unit.