Eaton TRIPP LITE Serie Guia De Inicio Rapido página 2

Installation
Instalación / Installation /
Installation / Installazione
Notes:
1. Test to make sure the entire installation works properly before pulling cables through ceilings/
walls.
2. To achieve maximum distance and performance, 24 AWG solid-wire Cat5e/6 cable must be used.
The use of stranded-wire Cat5e/6 cable or cable with a gauge size higher than 24 AWG will result
in a shorter extension distance. N202-Series Cat6 cables are made with 24 AWG solid-wire
cabling.
3. Make sure the power to all connected devices is turned off prior to installation.
2 2
1 1
DISPLAYPORT
COMPUTER
1
Connect the transmitter's built-in DisplayPort cable to the computer's
DisplayPort output port.
2
Connect the included USB Micro-B cable to the transmitter and a USB port on
the computer or a USB wall outlet. The green and orange LEDs on the
transmitter's RJ45 ports will illuminate to indicate it is receiving power from
the USB Micro-B cable.
3
Connect the RJ45 port on the transmitter to the RJ45 port on the receiver
using Cat5e/6 cable.
Note: See the installation diagrams for maximum extension distance at 1080p and 1080i
video resolutions.
4
Connect the receiver's built-in HDMI cable to an HDMI monitor input port.
5
Connect the included USB Micro-B cable to the receiver and a USB port on
the display or a USB wall outlet. The green LED on the receiver's RJ45 port will
illuminate to indicate it is receiving power from the USB Micro-B cable.
6
Power on the DisplayPort source and HDMI display. The orange LED on the
receiver's RJ45 port will illuminate to indicate it is receiving a signal from the
source.
2
3 3
24 AWG SOLID-WIRE
Cat5e/6 CABLE
Up to 125 ft. at 1080p
Up to 150 ft. at 1080i
5 5
4 4
HDMI DISPLAY