Kenmore 6800 Manual De Uso Y Cuidado página 11

the Heated Drying Rack
Use the Heated Drying Rack for items that you do not want
to tumble dry, such as sweaters. When you use the heated
drying rack, the heated air inside the dryer flows in a
concentrated pattern to allow efficient and uniform drying.
NOTE: Do not remove lint screen.
1. Open dryer door.
2. Slide dryer rack over the bottom of the dryer door
opening. Push down to secure it on the frame.
3. Place wet items on top of the rack. Allow space around
items for air to circulate. The rack does not move, but
the drum will rotate. Make sure items do not hang over
the edges or between rack grill.
4. Close dryer door.
5. Turn cycle knob to Time Dry.
6. Select a Dry Temp to match the fabrics in your load.
Items containing foam, rubber, or plastic must be dried
on a clothesline or by using Air Only. See "Cycle Guide".
7. Use TIME DRY to select the desired time. Select a time
by pressing MORE TIME or LESS TIME. Reset time as
needed to complete drying. See "Cycle Guide".
8. Start the dryer.
To remove the drying rack, lift it straight up and out
of the dryer.
NOTE: Check the lint screen and remove any lint
accumulated from items dried on the rack.
Changing the drum light (on some models)
1. Unplug dryer or disconnect power.
2. Open the dryer door. Locate the light bulb cover on the
back wall of the dryer. Using a Phillips head screw driver,
remove the screw located in the lower right-hand corner
of the cover. Remove the cover.
3. Turn bulb counterclockwise. Replace the bulb with
a 10-watt appliance bulb only. Replace the cover
and secure with the screw.
4. Plug in dryer or reconnect power.
Changing the EvenHeat
TM
Auto Dry Cycle
Settings to increase Drying Time
If all your loads on all Auto Dry cycles are consistently
not as dry as you would like, you may change the default
settings to increase the default dryness level.
Your Auto Dry settings can be adjusted to adapt to
different installations, environmental conditions or personal
preference. This change Js retained and will affect all
of your Auto Dry cycles, not just the current cycle!load.
There are 3 drying settings, which are displayed using
the Cycle Status light (Wet, Damp, Cool Down LEDs)
1 Factory preset dryness level.
2 Slightly drier clothes, 15% more drying time.
3 Much drier clothes, 30% more drying time.
To change the drying settings (on some models):
NOTE: The settings cannot be changed while the dryer
is running or paused. The dryer must be in standby mode
(the Power button is off:) to adjust the default settings.
1. Before starting a cycle, press and hold the DRY TEMP
button for 6 seconds.
2. Press the DRY TEMP button to select the dryness level
shown in the cycle status light display: Wet light
on : level 1, Wet and Damp lights on : level 2, and
Wet, Damp and Cool Down lights on : level 3.
3. Press START/PAUSE to save the new dryness level
setting.
11