Publicidad
Idiomas disponibles
Idiomas disponibles
D
6. CONTINUOUS USE (SEE FIG. E)
Depress on/off switch then lock-on button,
release on/off switch first and lock-on button
second. Your switch is now locked on for
continuous use. To switch off your tool just
depress and release the on/off switch.
1
E
7. CHANGING ROTATIONAL DIRECTION
(SEE FIG. F)
With the drill pointing away from you, push the
forward/reverse-lever to the "R" for forward
rotation. Push the forward/reverse-lever to the "L"
for reverse rotation.
WARNING: Never change the direction
of rotation while the tool is rotating, wait
until it has stopped.
F
34
2
8. FUNCTION SELECT (SEE FIG. G)
A) DRILLING FUNCTION
1) Press the lock button and rotate the selector
switch to make the triangle point to sign " ".
2) You are now set up for drilling function.
NOTE: You must press the selector switch lock
button before adjusting the selector switch. If
the selector switch cannot go into the required
position, switch on your hammer a little, then
adjust the selector switch again.
B) HAMMER DRILL FUNCTION
1) For drilling concrete, masonry etc, press the
lock button and rotate the selector switch to
make the triangle point to sign "
2) You are now set up for hammer drilling
function.
C) CHISEL ROTATION FUNCTION
Chisel rotation position "
the chiseling position. (Non-work position)
D) CHISEL FUNCTION
1) For chipping, grooving or demolition
operation, press the lock button and then
rotate the selector switch make the triangle
point to sign "
"
2) You are now set up for chisel work using
Chisel action.
WARNING: You must make sure that the
selector switch is positively locked in
chisel mode position. If not, it could cause a
hazard.
G
WORKING HINTS FOR
YOUR TOOL
1. Reduce the pressure on the drill bit when it is
about to break through. This will prevent the drill
from jamming.
2. When drilling a large hole, first drill a pilot hole
using a smaller drill bit.
3. Always apply pressure to your drill bit in a
".
" for adjustment of
Publicidad
