Publicidad
Idiomas disponibles
Idiomas disponibles
Runtime
Mode 3 up to min.
Mode 4 up to min.
Notes
¡ Like every Li-ion battery, the batteries
from the Power for ALL 18 V series wear
out over time, meaning that the battery
capacity and the runtime decrease. This
is a natural aging process and not the
result of a material error, manufacturing
error or material defect.
¡ You can delay the natural wear by using
the following measures:
– Only charge the battery in the temper-
ature range between 0 °C and 45 °C.
– Only store the battery in the temperat-
ure range between -20 °C and 50 °C.
– Do not store the battery for an exten-
ded period of time if it is fully charged
or fully discharged.
Operating the appliance
11
24
→ Fig.
-
Removing the appliance
→ Fig.
25
-
27
nozzle
mopping
the
Operating
Operating the mopping nozzle
nozzle
mopping
the
Operating
Overview of the mopping nozzle
You can find an overview of the parts of the
mopping nozzle here.
28
→ Fig.
Mopping nozzle release button
Water tank release button
Water tank
Mopping pads
LED status indicator
f
Water control button
g
Filling opening
h
Valve pin
3,0 Ah
15
8
Operating the mopping nozzle en
Filling the water tank
The use of water alone is sufficient for ef-
fective cleaning. If, however, you still want
to use a cleaning additive, this must meet
the following requirements.
▶ Do not fill with hot water above 50 °C.
▶ Dose cleaning additives according to the
manufacturer's instructions.
▶ Do not use wax, oils or cleaning addit-
ives that cannot be diluted with water.
▶ Do not use any non-transparent, milky,
chlorinated, acidic and foaming cleaning
additives (e.g. dishwasher detergent).
▶ Only use neutral multi-purpose cleaning
agents.
▶ Close the filling lid completely before in-
serting the water tank.
▶ Wipe up any residual water on the water
tank with an absorbent cloth.
29
34
→ Fig.
-
Attaching the mopping pads
▶ When the appliance is switched on, do
not attach the mopping pads.
→ Fig.
35
-
36
Using the nozzle
▶ Do not leave the appliance in one posi-
tion for more than 1 minute with the
nozzle and wet mopping pads attached,
regardless of whether the appliance is
switched on or off.
Tip: Use the automatic mode for the best
mopping results and a longer run time.
→ Fig.
37
-
40
Activating the water boost function
Tip: Use the water boost function to
moisten dry mopping pads more quickly or
to remove particularly stubborn stains.
▶
Press and hold
41
→ Fig.
a The LED status indicator flashes slowly.
a The water boost function is activated.
Note: The water boost stops automatically
after 30 seconds. The automatic water sup-
ply is then activated again.
for at least 3 seconds.
25
Publicidad
