Bosch BCS71HYG Manual De Usuario página 26

en Cleaning and servicing
servicing and Cleaning
Cleaning and servicing
To keep your appliance working efficiently
servicing and Cleaning
for a long time, it is important to clean and
maintain it carefully.
Cleaning the appliance
→ Fig. 42 - 42
Emptying the dust container
→ Fig. 43 - 46
Cleaning the filter unit
Note: It is recommended cleaning the filter
of the dust container whenever you empty
the container. It should however be done at
least once a month.
▶ Never allow the filters to come into con-
tact with liquids.
→ Fig. 47 - 53
Cleaning the floor nozzle
54 54
→ Fig. -
Emptying the water tank
→ Fig. 55 - 56
Cleaning and drying the mopping
pads
→ Fig. 57 - 60
Changing the mopping pads
▶
Tip: To achieve optimum cleaning res-
ults, change the mopping pads every
6 months. Immediately change heavily
soiled or damaged mopping pads.
→ Fig. 61
Troubleshooting
Troubleshooting
Troubleshooting
Tip: You can find further information and
explanations on troubleshooting online by
scanning the QR code on page 2 and on
our website www.bosch-home.com.
▶ Repairs to the appliance should only be
carried out by trained specialist staff.
▶ Only use genuine spare parts when re-
pairing the appliance.
26
The appliance is not working.
The battery status display does not show
any status.
The battery has not been inserted correctly.
▶
Insert the battery correctly.
The battery has not been charged.
▶
Charge the battery.
The red fault indicator lights up for 10
seconds.
The battery has overheated or overcooled.
Switch off the appliance and disconnect
1.
the appliance from the power supply.
Wait until battery has reached room
2.
temperature.
The appliance has overheated or
overcooled.
Switch off the appliance and disconnect
1.
the appliance from the power supply.
Wait until the appliance has reached
2.
room temperature.
No charging function.
Incorrect charger was used.
▶
Only use the charger that is included.
The dust container cannot be inserted.
The filter unit is not complete.
▶
Check whether the filter unit is com-
plete.
The filter unit or dust container is not
positioned correctly.
▶
Check whether the filter unit and dust
container are inserted correctly.
Suction is reduced.
The filter is blocked.
Switch off the appliance and disconnect
1.
the appliance from the power supply.
Clean the filter unit.
2.
Nozzle or suction pipe is blocked.
Switch off the appliance and disconnect
1.
the appliance from the power supply.
Check whether the air channel from the
2.
nozzle to the appliance is blocked.