Fein GRIT GXR Manual Del Usuario página 5

Original Instructions. en
Symbols, abbreviations and terms used.
The symbols in the Instruction Manual and on the machine shall aide in directing your attention to possible hazardous
situations when working with this machine.
Symbol, character Explanation
Do not touch the rotating parts of the machine.
Observe the instructions in the text or graphic opposite!
Make sure to read the enclosed documents such as the Instruction Manual and the General Safety
Instructions.
Before commencing this working step, pull the mains plug out of the socket. Otherwise there
may be danger of injury caused by unintentional starting of the machine.
Use eye protection during operation.
Use ear protection during operation.
Use a dust mask during operation.
Use protective gloves during operation.
Danger warning
This symbol confirms the certification of this product for the USA and Canada.
Worn out machine and other electrotechnical and electrical products should be sorted
separately for environmental-friendly recycling.
Rotation direction
(**) may contain numbers and letters
Character Unit of measurement, national
l1
in, mm
l2
in, mm
lbs, kg
m, s, kg, A, mm, V, W, Hz, N, °C,
dB, min, m/s2
For your safety.
Do not use the radius grinding module before you
have thoroughly read and completely understood
these operating instructions, including the figures,
specifications, and safety regulations.
Read and observe the operating instructions of the
belt grinder GX75/GX752H, to which this
machine is to be mounted.
This Instruction Manual should be kept for later use and
enclosed with the power tool, should it be passed on or
sold.
Explanation
Sanding-belt length
Sanding-belt width
Weight
Basic and derived units of measurement from the interna-
tional system of units SI.
For assembly of the radius grinding module to the belt
grinder, use only the fastening material provided. Faulty
assembly can cause the radius grinding module to loosen
from the belt grinder during operation and lead to seri-
ous accidents.
Intended use of the machine.
The radius grinding module GXR is to be used together
with the belt grinder GX75/GX752H exclusively for
grinding off metal pipe ends (except magnesium) with
diameters between 5/8 - 2 61/64" using the application
tools and accessories recommended by FEIN in weather-
protected environments.
en
5