Giordani ADONIS Manual De Instrucciones página 24

CHECKING THE SHOULDER
15. A: Not-too low
B: Not-too high
C: Yes-correct
Make sure that the harness is
level with your child's shoulders.
Otherwise, move the shoulder
strap up or down to the correct slot.
CONCEALING THE HARNESS
SYSTEM (suitable for children
with a height of 100 cm-150 cm)
16. Release the five-point buckle.
17. Remove the buckle pad and inner
cushion.
18. Pull up the headrest and lift the
lower back cushion.
19. Undo the three buttons on the
fabric cover on the back of the seat
and move it to the right.
20. Hide the shoulder strap and
shoulder pad sleeve and do up all
the buttons on the back.
21. Place the buckle tongue and the
buckle under the seat base cover.
22. Insert the buckle tongue and
buckle into the storage slot in the
base of the seat.
23. Tighten the shoulder straps of
the seat correctly, making sure
that they are not too tight, as this
would prevent normal use.
INSTALLATION WITH ADULT
SAFETY BELT (100-150 cm)
24. Forward Facing:
Child height 100 cm-150 cm
i-Size Booster seat.
Place the child safety seat on the
car seat. Pull out the seat belt
completely.
R390_ADONIS_(YC 13)_ Priorità 3_Libretto_8.indd 24 R390_ADONIS_(YC 13)_ Priorità 3_Libretto_8.indd 24
STRAP HEIGHT
25. Place the child in the seat and adjust
the headrest to the appropriate
height.
26. The shoulder strap must pass
through the shoulder strap guide
and the lap belt must go under the
armrest on the seat base. Make
sure that the car seat belt does not
hurt the child's neck.
27. Insert the metal tongue of the car
seat belt into the car seat buckle
until you hear it click into place.
28. Tighten the seat belt and make
sure it is not twisted.
REMOVING/INSTALLING
THE COVER
Remove the buckle pad and inner
cushion.
29. Undo the three buttons on the back-
rest cover and move it to the right.
30. Loosen all fastening buttons on
the shoulder pad sleeve.
31. Pull upwards to take the shoulder
pad out of the hole.
32. Pull downwards to take the
shoulder pad out. Lower the fabric
cover of the headrest.
33. Remove the fabric cover from the
headrest.
34. R e m o v i n g t h e b a c k r e s t :
disconnect the backrest and base,
take out the backrest hook from
the rubber band on the seat cover
of the base, then separate the
backrest from the base.
35. Take off the backrest cover by
lifting it up.
36. Remove the base cover by lifting
it up. Seat fabric cover fitted: to
assemble the soft goods, repeat
the steps above in reverse order.
24
Safety
After re
insert
where
• Was
belo
• Do n
• Do n
goo
• Do
dete
solv
It m
rest
• Whe
twis
cau
• Plea
in th
W
system
withou
Please
parts a
in goo
accide
use, re
the ve
in the
your c
do no
and h
period
carefu
22/12/23 10:42 22/12/23 10:42