Publicidad
Idiomas disponibles
Idiomas disponibles
6 Troubleshooting
Paper jam
You have fed in too much paper.
Notice
Do not press rocker switch alter-
nately forwards/backwards (
unit could be damaged.
• Press rocker switch
Pa per is pus hed out.
• Se pa ra te pa per stack.
• Press rocker switch
• Feed in pa per successively.
Shredded material container full
Notice
Empty the cut material container,
immediately because if it is too full, malfunc-
tions can occur in the cutting system.
• Press automatic start stop control
for 2 sec.
• Switch equipment off. To do this
tap rocker switch
• Move cutting head away.
• Empty cut material container.
• Remove cutting head.
For all other malfunctions, check whether
the cutting head was correctly positioned on
the shredded material container before con-
tacting our customer service. If the motor
was overloaded, let the shredder cool down
for 15 to 20 minutes before using it again.
12
7 Cleaning and maintenance
-
). Cutting
When cleaning only use a soft cloth and a
mild soap-water solution. However, no water
.
must enter the equipment.
.
container (Cross cut only):
• Spray special cutting block oil through pa-
per feed opening across the whole width
of the cutting system blades.
• Press automatic start stop control and run
cutting system forwards and backwards
(
.
per. Paper dust and particles are shaken
off.
8 Disposal / Recycling
gerous to your health and the environment.
Never dispose of old devices in the house-
hold waste. Observe the current applicable
regulations and use the collection points for
returning and recycling electric and elec-
tronic devices. Dispose of all the packaging
materials also in an environmentally-respon-
sible way.
Classic 90.2 • Primo 900
english
WARNING
Dangerous mains voltage!
Switch off the shredder and pull
out the mains plug.
Oil the cutting unit when
cutting performance de-
creases or the device
becomes noisy, or every
time you empty the waste
-
) several times without feeding pa-
Electrical and electronic old de-
vices contain a variety of valuable
materials, but also hazardous
substances which were required
for function and safety. Incorrect
disposal or handling can be dan-
09/2011
Publicidad
