Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
6. Connecting the water supply to the product
•
Uncoil the garden hose.
•
Let the water flow through the garden hose
for 30 seconds to clean out any debris.
•
Turn the water supply off.
•
Install and tighten the end of the garden hose
to the water inlet (J) connector.
NOTE: For easy operation, please use a
self-coiling garden hose (not provided).
WARNING
When you operate the self-coiling hose, make sure
that the hose has no blockage.
•
The water supply must come from the water
main.
•
Do not use hot water.
•
Do not use water from ponds or lakes.
•
Always observe all the local regulations
when you connect the garden hose to the
water supply. Direct connection through a
receiver tank or backflow preventer is usually
permitted.
CAUTION
Inspect the filter in the water inlet connector before
you connect the garden hose.
•
If the filter is damaged, do not use the product
until the filter is replaced.
•
If the filter is dirty, clean the filter.
7. Installing the high pressure hose
•
Push and turn counterclockwise one end
of the high pressure hose (M) into the inlet
coupler.
•
Install and tighten the other end of the high
pressure hose onto the water outlet (G)
coupler.
CAUTION
There must be a minimum of 10 feet of free hose
between the water inlet and the water supply.
6
7
10
J
M
G
Publicidad
