Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
4. Installing the air release valve
NOTE: Use air release valve when using siphon
tube.
•
Before installing the included high pressure
hose, place the air release valve (GG) onto
the pressure water outlet (G) and rotate clock-
wise until tightened.
•
Or directly connect the high pressure hose
to the water outlet (G), when not using the
siphon hose.
WARNING
Water exiting the air release valve (GG) is normal.
This valve bleeds air from the pump and will en-
able the siphon function.
5a. Installing the self-siphon hose
NOTE: The pressure washer can absorb water
from water buckets, containers, and approved
stagnant bodies of water.
NOTE: Exhaust the siphon hose for 30 seconds
before installing the spray tip when using the
siphon function.
•
Add water to the bucket.
5b. Installing the self-siphon hose
•
Insert one end of the self-siphon hose into
the water inlet (J). And put the other end of
the self-siphon hose (HH) into the bucket (not
included).
NOTE: When you use the self-siphon hose, you
should do the below instructions:
•
The vertical height of the self-siphon hose
(HH) cannot exceed 4-ft.
•
The internal self-siphon hose size is 0.03 ft -
0.04 ft (10 mm - 12 mm).
•
A filter should be installed at the end of the
self-siphon hose (HH) into the bucket.
4
5a
5b
9
G
GG
J
HH
Publicidad
